Table of Contents
Advertisement
Command Reference Guide
show ip route
Use the show ip route command to display the contents of the Internet Protocol version 4 (IPv4) route
table. Variations of this command include:
show ip route
show ip route <ipv4 address>
show ip route <ipv4 address> <subnet mask>
show ip route <ipv4 address> longer-prefixes
show ip route <ipv4 address> <subnet mask> longer-prefixes
show ip route bgp
show ip route bgp verbose
show ip route connected
show ip route ospf
show ip route ospf verbose
show ip route rip
show ip route rip verbose
show ip route static
show ip route static verbose
show ip route summary
show ip route summary realtime
show ip route table
show ip route vrf <name>
show ip route vrf <name> <ipv4 address>
show ip route vrf <name> <ipv4 address> <subnet mask>
show ip route vrf <name> <ipv4 address> longer-prefixes
show ip route vrf <name> <ipv4 address> <subnet mask> longer-prefixes
show ip route vrf <name> bgp
show ip route vrf <name> connected
show ip route vrf <name> ospf
show ip route vrf <name> rip
show ip route vrf <name> static
show ip route vrf <name> summary
show ip route vrf <name> table
The output of all show commands can be limited by appending the following modifiers to
the end of the command: | begin <text>, | exclude <text>, and | include <text>. The
include modifier limits output to lines that contain the specified text, the exclude modifier
excludes any lines with the specified text, and the begin modifier displays the first line of
output with the specified text and all lines thereafter.
For specific instructions and examples regarding these modifiers, refer to the introduction
of the
Enable Mode Command Set on page
60000CRG0-35E
83.
Copyright © 2012 ADTRAN, Inc.
Enable Mode Command Set
590
Advertisement
Table of Contents
