ADTRAN AOS Version R10.1.0 Command Reference Manual page 624

Command Reference Guide
show ipv6 dhcp binding
Use the show ipv6 dhcp binding command to display details about stateful information assigned and
bound to individual Dynamic Host Control Protocol version 6 (DHCPv6) clients as maintained by the
DHCPv6 server. Variations of this command include:
show ipv6 dhcp binding
show ipv6 dhcp binding <ipv6 address>
show ipv6 dhcp binding <ipv6 address> summary
show ipv6 dhcp binding summary
show ipv6 dhcp binding vrf <name>
show ipv6 dhcp binding vrf <name> <ipv6 address>
show ipv6 dhcp binding vrf <name> <ipv6 address> summary
show ipv6 dhcp binding vrf <name> summary
The output of all show commands can be limited by appending the following modifiers to
the end of the command: | begin <text>, | exclude <text>, and | include <text>. The
include modifier limits output to lines that contain the specified text, the exclude modifier
excludes any lines with the specified text, and the begin modifier displays the first line of
output with the specified text and all lines thereafter.
For specific instructions and examples regarding these modifiers, refer to the introduction
of the Enable Mode Command Set on page
Syntax Description
<ipv6 address>
summary
vrf <name>
Default Values
No default values necessary for this command.
Command History
Release R10.1.0
60000CRG0-35E
Optional. Limits the output to a single DHCPv6 client IPv6 address. IPv6
addresses should be expressed in colon hexadecimal format (for example,
2001:DB8:1::1.
Optional. Summarizes the command output.
Optional. Limits output to a nondefault VPN routing and forwarding (VRF)
instance. If no VRF is specified, bindings on all VRF instances are
displayed.
Command was introduced.
Copyright © 2012 ADTRAN, Inc.
Enable Mode Command Set
83.
624