ADTRAN AOS Version R10.1.0 Command Reference Manual page 953

Command Reference Guide
garp timer <value>
Use the garp timer command to adjust the timers used in all Generic Attribute Registration Protocol
(GARP) applications (currently only GARP VLAN Registration Protocol (GVRP)) on the switch. Use the
no form of this command to return to the default setting. Variations of this command include:
garp timer join <value>
garp timer leave <value>
garp timer leaveall <value>
Syntax Description
join <value>
leave <value>
leaveall <value>
Default Values
By default, the join timer is 200 milliseconds, the leave timer is 600 milliseconds, and the leaveall timer is
10000 milliseconds.
Command History
Release 8.1
Functional Notes
All devices communicating using GARP in the network need to have the same values for these timers.
Changing these values is not recommended.
Usage Examples
The following example specifies the time (in milliseconds) between GARP application leave all messages:
(config)#garp timer leaveall 20000
60000CRG0-35E
Specifies the timer value (in milliseconds) between GARP application join
messages.
Specifies the timer value (in milliseconds) between GARP application leave
messages (must be at least three times longer than the join timer).
Specifies the timer value (in milliseconds) between GARP application leave
all messages (must be greater than the leave timer).
Command was introduced.
Copyright © 2012 ADTRAN, Inc.
Global Configuration Mode Command Set
953