ADTRAN AOS Version R10.1.0 Command Reference Manual page 321

Command Reference Guide
debug ipv6 dhcp
Use the debug ipv6 dhcp command to enable debug messages for Dynamic Host Control Protocol
version 6 (DHCPv6) operation in AOS. Debug messages are displayed (real time) to the terminal (or
Telnet) screen. Use the no form of this command to disable the debug messages. Variations of this
command include:
debug ipv6 dhcp detail
debug ipv6 dhcp relay
debug ipv6 dhcp server
Turning on a large amount of debug information can adversely affect the performance of
your unit.
Syntax Description
detail
relay
server
Default Values
No default values are necessary for this command.
Command History
Release 18.3
Usage Examples
The following example displays sample output for DHCPv6 relay debug information:
>enable
#debug ipv6 dhcp relay
2011.01.01 21:40:24 DHCPv6.RELAY Relaying SOLICIT from FE80::B098:1B0E:27CA:A8AB on eth 0/2
2011.01.01 21:40:24 DHCPv6.RELAY to FE80::2A0:C8FF:FE65:702 eth 0/1
2011.01.01 21:40:24 DHCPv6.RELAY Sending RELAY-FORWARD to FE80::2A0:C8FF:FE65:702 eth 0/1
2011.01.01 21:40:24 DHCPv6.RELAY Received RELAY-REPLY from FE80::2A0:C8FF:FE65:702 eth 0/1
2011.01.01 21:40:24 DHCPv6.RELAY Relaying RELAY-REPLY from FE80::2A0:C8FF:FE65:702 eth 0/1
2011.01.01 21:40:24 DHCPv6.RELAY to FE80::B098:1B0E:27CA:A8AB on eth 0/2
2011.01.01 21:40:24 DHCPv6.RELAY Sending REPLY to FE80::B098:1B0E:27CA:A8AB eth 0/2 on eth
0/2
60000CRG0-35E
Specifies that DHCPv6 packet content is displayed.
Specifies that DHCPv6 relay information is displayed.
Specifies that DHCPv6 server information is displayed.
Command was introduced.
Copyright © 2012 ADTRAN, Inc.
Enable Mode Command Set
321