ADTRAN AOS Version R10.1.0 Command Reference Manual page 598

Command Reference Guide
show ip rtp quality-monitoring
Use the show ip rtp quality-monitoring command to display a summary of all voice quality monitoring
(VQM) statistics gathered from monitoring inbound Realtime Transport Protocol (RTP) streams across the
network.
The output of all show commands can be limited by appending the following modifiers to
the end of the command: | begin <text>, | exclude <text>, and | include <text>. The
include modifier limits output to lines that contain the specified text, the exclude modifier
excludes any lines with the specified text, and the begin modifier displays the first line of
output with the specified text and all lines thereafter.
For specific instructions and examples regarding these modifiers, refer to the introduction
of the Enable Mode Command Set on page
Syntax Description
No subcommands.
Default Values
No default values are necessary for this command.
Command History
Release 17.1
Usage Examples
The following example displays a summary of all gathered VQM statistics:
#show ip rtp quality-monitoring
Voice Quality Monitoring is ENABLED
Jitter Buffer: adaptive 10/50/100 ms (min/nominal/max)
Quality Active Streams
---------- ---------------------
Excellent 60
Good 20
Fair 3
Poor 1
----------- ---------------------
Totals: 84
(Note: Statistics for All Streams are updated at call completion and do not include currently active
streams. Call history statistics are available for up to 100 streams.)
History thresholds:
MOS (LQ/CQ/PQ): 3.0/3.0/3.0
Loss: 20 pkts
60000CRG0-35E
Command was introduced.
Call History
----------------
50
37
1
7
---------------
95
Copyright © 2012 ADTRAN, Inc.
Enable Mode Command Set
83.
All Streams MOS range
---------------- ----------------
13462 4.40 - 4.00
3456 3.99 - 3.60
45 3.59 - 2.60
7 2.59 - 0.00
--------------- ----------------
16970
598