ADTRAN AOS Version R10.1.0 Command Reference Manual page 213

Command Reference Guide
copy tftp
Use the copy tftp command to copy a file located on a network Trivial File Transfer Protocol (TFTP)
server to a specified destination.
Variations of this command (valid on all AOS units) include:
copy tftp flash
copy tftp running-config
copy tftp startup-config
Variations of this command (valid only on AOS units WITH CompactFlash
copy tftp cflash
Variations of this command (valid only on AOS units WITH CompactFlash AND voice capability)
include:
copy tftp dynvoice-config
Variations of this command (valid only on AOS units WITH ramdisk enabled) include:
copy tftp ramdisk
Variations of this command (valid only on AOS units WITH Universal Serial Bus (USB) flash drive
capability) include:
copy tftp usbdrive0
Syntax Description
cflash
dynvoice-config
flash
ramdisk
running-config
startup-config
60000CRG0-35E
Copies a file from the TFTP server to the CompactFlash card.
Specifies that the file copied from the TFTP server overwrite the dynamic
voice configuration file.
Copies a file from the TFTP server to the flash memory.
Copies a file from the TFTP server to the volatile RAM disk.
Replaces the active running configuration with the file copied from the TFTP
server.
Replaces the startup configuration with the file copied from the TFTP
server.
After entering copy tftp and specifying the destination, AOS prompts for the
following information:
Address of remote host:
Source filename:
Destination filename:
Copyright © 2012 ADTRAN, Inc.
Enable Mode Command Set
®
capability) include:
Specifies the IP address of the TFTP server.
Specifies the name of the file to copy from the
TFTP server.
Specifies the file name to use when storing the
copied file. (Valid only for the copy tftp cflash,
copy tftp flash, copy tftp ramdisk commands.)
213