ADTRAN AOS Version R10.1.0 Command Reference Manual page 532

Command Reference Guide
Usage Examples
The following is sample output for the AP interface 1 using the show interfaces dot11ap command:
>enable
#show interfaces dot11ap 1
Dot11 AP 1 line protocol is UP
Controller Status: Local AC in control
Ap Version: FW: 1.0 0.4, DRVR: 1.0 0.0, HW: 1.0 0.0
Ap S/N: LBADTN0625XC975
AP MAC address: 00:A0:C8:1D:F8:57
Radio1 - 802.11bg - Enabled, channel 0, address: 00:A0:C8:1D:F8:59
Radio2 - 802.11a - Disabled, channel 0, address: 00:A0:C8:1D:F8:58
Bootup Status: Normal
Ap Status: With Session
Controlling AC: 00:A0:C8:20:E7:D6
802.1Q Encapsulation - Disabled
Auto 100Mbps, Full Duplex
Ethernet Statistics:
Ethernet Rx Packets: 291476
Ethernet Rx Bytes: 20908434
Ethernet Tx Packets: 67346
Ethernet Tx Bytes: 10606783
The following is sample output for the AP interface 1 using the show interfaces dot11ap <ap>
control-protocol command:
>enable
#show interfaces dot11ap 1 control-protocol
AP State: Running with session
Control State: Controlled by this AC
Control Protocol Transmit Bytes: 4080386
Control Protocol Receive Bytes: 9435172
Control Protocol Transmit Packets: 52203
Control Protocol Receive Packets: 65931
Control Protocol Receive Keepalives: 14914
Control Protocol Receive Security Errors: 0
Control Protocol Dropped Packets: 0
Control Protocol Protocol Errors: 0
Control Protocol Protocol No Responses: 0
60000CRG0-35E Copyright © 2012 ADTRAN, Inc.
Enable Mode Command Set
532