ADTRAN AOS Version R10.1.0 Command Reference Manual page 582

Command Reference Guide
show ip policy-sessions
Use the show ip policy-sessions command to display a list of current Internet Protocol version 4 (IPv4)
access control policy (ACP) associations. Refer to
information on configuring ACPs. Variations of this command include:
show ip policy-sessions
show ip policy-sessions pending
show ip policy-sessions timeline
show ip policy-sessions <ipv4 acp name>
show ip policy-sessions <ipv4 acp name> include-deleted
show ip policy-sessions <ipv4 acp name> timeline
show ip policy-sessions any-vrf
show ip policy-sessions any-vrf include-deleted
show ip policy-sessions any-vrf timeline
show ip policy-sessions include-deleted
show ip policy-sessions vrf <name>
show ip policy-sessions vrf <name> include-deleted
show ip policy-sessions vrf <name> timeline
The output of all show commands can be limited by appending the following modifiers to
the end of the command: | begin <text>, | exclude <text>, and | include <text>. The
include modifier limits output to lines that contain the specified text, the exclude modifier
excludes any lines with the specified text, and the begin modifier displays the first line of
output with the specified text and all lines thereafter.
For specific instructions and examples regarding these modifiers, refer to the introduction
of the Enable Mode Command Set on page
Syntax Description
<ipv4 acp name>
include-deleted
pending
timeline
any-vrf
60000CRG0-35E
ip policy-class <ipv4 acp name> on page 1058
Optional. Displays policy class associations for the specified IPv4 ACP.
Optional. Displays all IPv4 ACP firewall sessions, including active
associations (through which the firewall is allowed to pass traffic), and
associations flagged for deletion (through which the firewall is forbidden to
pass traffic). Associations flagged for deletion will usually be freed within a
few seconds of timeout or deletion, depending on packet congestion;
servicing of packets is given priority. New traffic matching an association will
create a new active association, provided the traffic still matches an ACP
allow or network address translation (NAT) entry. (This parameter is only
valid on the NetVanta 3200.)
Optional. Displays any currently pending ACP sessions.
Optional. Displays a timeline of IPv4 ACP firewall session creations and
peak numbers of policy sessions per hour over the last 24 hours.
Optional. Displays information for all VPN routing and forwardings (VRFs),
including the default.
Copyright © 2012 ADTRAN, Inc.
Enable Mode Command Set
83.
for
582