ADTRAN AOS Version R10.1.0 Command Reference Manual page 517

Command Reference Guide
show hw-access-map
Use the show hw-access-map command to display hardware access map configuration and statistics.
Variations of this command include:
show hw-access-map
show hw-access-map <name>
The output of all show commands can be limited by appending the following modifiers to
the end of the command: | begin <text>, | exclude <text>, and | include <text>. The
include modifier limits output to lines that contain the specified text, the exclude modifier
excludes any lines with the specified text, and the begin modifier displays the first line of
output with the specified text and all lines thereafter.
For specific instructions and examples regarding these modifiers, refer to the introduction
of the Enable Mode Command Set on page
Syntax Description
<name>
Default Values
No default values are necessary for this command.
Command History
Release 17.6
Usage Examples
The following is sample output from the show hw-access-map <name> command, using the access map
HW-FILTER:
>enable
#show hw-access-map HW-FILTER
Hardware Access Map HW-FILTER
Forward: mac ADTN and ip NET135
VLANs: 2-3
60000CRG0-35E
Optional. Displays only the statistics for the named hardware access map.
Command was introduced.
Copyright © 2012 ADTRAN, Inc.
Enable Mode Command Set
83.
517