Show Ip Protocols - ADTRAN AOS Version R10.1.0 Command Reference Manual

Command Reference Guide

show ip protocols

Use the show ip protocols command to display IP routing protocol parameters and statistics. Variations of
this command include:
show ip protocols
show ip protocols vrf <name>
The output of all show commands can be limited by appending the following modifiers to
the end of the command: | begin <text>, | exclude <text>, and | include <text>. The
include modifier limits output to lines that contain the specified text, the exclude modifier
excludes any lines with the specified text, and the begin modifier displays the first line of
output with the specified text and all lines thereafter.
For specific instructions and examples regarding these modifiers, refer to the introduction
of the Enable Mode Command Set on page
Syntax Description
vrf <name>
Default Values
No default values are necessary for this command.
Command History
Release 3.1
Release 17.1
Release 18.3
Usage Examples
The following is sample output from the show ip protocols command:
>enable
#show ip protocols
Sending updates every 30 seconds, next due in 8 seconds
Invalid after 180 seconds, hold down time is 120 seconds
Redistributing: rip
Default version control: send version 2, receive version 2
Interface Send Ver.
eth 0/1 2
ppp 1 2
Routing for networks:
1.1.1.0/24
60000CRG0-35E
Optional. Displays IP routing protocol parameters and statistics for the
specified VPN routing and forwarding (VRF) instance. If no VRF is
specified, statistics displayed are for the default (unnamed) VRF instance.
Command was introduced.
Command was expanded to include the modifiers begin, exclude, and
include.
Command was expanded to include the vrf <name> parameter.
Rec Ver.
2
2
Copyright © 2012 ADTRAN, Inc.
Enable Mode Command Set
83.
589