ADTRAN AOS Version R10.1.0 Command Reference Manual page 187

Command Reference Guide
Release A4.05
Release A5.01
Functional Notes
Updates to the boot ROM are required periodically to enhance and expand the unit's operation. The
bootcode can be updated from within the command line interface (CLI) using the copy <source file> boot
command.
Usage Examples
The following example copies the file myfile.biz (located in flash memory) and overwrites the boot ROM:
>enable
#copy myfile.biz boot
Upgrading bootcode is a critical process that cannot be interrupted. If something were to happen and the
process was not able to be completed, it would render your unit inoperable. It is for this reason that during
a bootcode upgrade, all other system tasks will be halted. This means packets will not be routed, and all
console sessions will not respond during the upgrade process. Once the process finishes, the system will
function as it did before. This process will take approximately 20 seconds.
Do you want to proceed? [yes/no]y
WARNING!! A bootcode upgrade has been initiated. Your session will become
nonresponsive for the duration of the upgrade (approx. 20 seconds). A message
will be sent when the upgrade is completed.
Bootcode upgrade process done. Your session should function normally.
Success!!!!!
60000CRG0-35E
Command was expanded to include the asymmetric digital subscriber line
(
ADSL) interface.
Command was expanded to include the fpga parameter.
Copyright © 2012 ADTRAN, Inc.
Enable Mode Command Set
187