ADTRAN AOS Version R10.1.0 Command Reference Manual page 195

Command Reference Guide Enable Mode Command Set
The following example copies the dynamic voice configuration file (using the XMODEM protocol) and
saves it to the terminal connected to the console port:
>enable
#copy dynvoice-config xmodem
Begin the Xmodem transfer now...
Press CTRL+X twice to cancel
CCCCCC
AOS is now ready to transmit the file on the CONSOLE port (using the XMODEM protocol). The next step
in the process may differ depending on the type of terminal emulation software you are using. For
HyperTerminal, you will now select Transfer > Receive File and select the destination. Once the transfer
is complete, information similar to the following is displayed:
Sent 5221 bytes.
Transfer complete
60000CRG0-35E Copyright © 2012 ADTRAN, Inc. 195