ADTRAN AOS Version R10.1.0 Command Reference Manual page 1178

Command Reference Guide
ip urlfilter max-response <value>
Use the ip urlfilter max-response command to set the maximum number of responses allowed to buffer
before receiving an allow or block status from the uniform resource locator (URL) filter server. Use the no
form of this command to set the value back to its default setting.
Syntax Description
<value>
Default Values
By default, the value of buffered responses is 100.
Command History
Release 12.1
Functional Notes
When a URL request comes through the unit and URL filtering is enabled, a lookup request is sent to the
URL filter server and the Hypertext Transfer Protocol (HTTP) request is forwarded to the HTTP server at
the same time. If the HTTP server responds before the URL filter server, the response must be buffered
until the URL filter server responds with allow or block. Once the maximum number of buffered HTTP
responses is reached, all following HTTP responses are dropped until some of the existing buffered
responses are released. Buffered responses are released when the URL filter server sends a response, or
when the firewall association times out.
Usage Examples
The following example sets the maximum number of buffered responses to 50:
(config)#ip urlfilter max-response 50
60000CRG0-35E
Specifies the maximum number of responses allowed to buffer. Valid range
is 1 to 100 responses.
Command was introduced.
Copyright © 2012 ADTRAN, Inc.
Global Configuration Mode Command Set
1178