ADTRAN AOS Version R10.1.0 Command Reference Manual page 392

Command Reference Guide
repeat <number>
size <value>
source <ipv4 address>
timeout <value>
verbose
vrf <name>
wait <interval>
Default Values
By default, the data pattern is set to abcd.
By default, the repeat is set to 5.
By default, the size value is set to 100 bytes.
By default, the timeout value is set to 2 seconds.
By default, the wait value is set to 100 milliseconds.
Command History
Release 1.1
Release 16.1
Release 17.2
Release 17.4
Release A4.01
Release 18.3
Functional Notes
The ping command can be issued from both the Basic and Enable modes.
The ping command helps diagnose basic IPv4 network connectivity using the Packet Internet Groper
program to repeatedly bounce Internet Control Message Protocol version 4 (ICMPv4) ECHO_REQ
packets off a system (using a specified IPv4 address). AOS allows executing a standard ping request to a
specified IP address, or provides a set of prompts to configure a more specific ping configuration.
60000CRG0-35E
Optional. Specifies the number of loopback messages to be sent. Range is
1 to 1024.
Optional. Specifies the datagram size (in bytes) of the ping packet. Valid
range is 1 to 1448 bytes.
Optional. Specifies the IPv4 address to use as the source address in the
ECHO_REQ (or interface) packets. The source IPv4 address must be a
valid address local to the router on the specified VPN routing and
forwarding (VRF) instance.
Optional. Specifies the timeout period after which the ping is considered
unsuccessful. Valid range is 1 to 60 seconds.
Optional. Enables detailed messaging.
Optional. Specifies the VRF where the IPv4 address exists.
Optional. Specifies a minimum time to wait between sending test packets.
Valid range is 100 to 60000 milliseconds.
Command was introduced.
Command was expanded to include the vrf parameter.
Command was expanded to include the verbose and wait parameters, also
changes were made to the repeat and timeout values.
Command was expanded to include the count and interval parameters.
The repeat and wait parameters were removed.
Command was expanded to return the wait parameter.
Command was expanded to include the optional ip and <interface>
parameters.
Copyright © 2012 ADTRAN, Inc.
Enable Mode Command Set
392