ADTRAN AOS Version R10.1.0 Command Reference Manual page 337

Command Reference Guide
debug mgcp verbose
Use the debug mgcp verbose command to display detailed information about Media Gateway Control
Protocol (MGCP) transmissions and receptions.
Turning on a large amount of debug information can adversely affect the performance of
your unit.
Syntax Description
No subcommands.
Default Values
No default values are necessary for this command.
Command History
Release A2
Usage Examples
The following is sample output from the debug mgcp verbose command:
#debug mgcp verbose
19:02:35 MGCP.STACK DEBUG adEndpointEvent(int=0:1, pkg=, evt=hd)
19:02:35 MGCP.STACK MSG TX: -> 47.234.101.60:2727
19:02:35 MGCP.STACK MSG TX: ntfy 58 aaln/1@65.162.109.238 MGCP 1.0
19:02:35 MGCP.STACK MSG RX: <- 47.234.101.60:2727
19:02:35 MGCP.STACK MSG RX: 200 58 OK
19:02:35 MGCP.STACK MSG RX: <- 47.234.101.60:2727
19:02:35 MGCP.STACK MSG RX: RQNT 30081 aaln/1@65.162.109.238 MGCP 1.0
60000CRG0-35E
Command was introduced.
K: 57
X: 22410
O: l/hd
X: 22414
S:
R: L/hu(N)
Q: loop
Copyright © 2012 ADTRAN, Inc.
Enable Mode Command Set
337