ADTRAN AOS Version R10.1.0 Command Reference Manual page 664

Command Reference Guide
show mac address-table interface
Use the show mac address-table interface command to display information regarding medium access
control (MAC) address table entries specific to a certain interface. Variations of this command include:
show mac address-table interface <interface>
show mac address-table interface <interface> vlan <vlan id>
The output of all show commands can be limited by appending the following modifiers to
the end of the command: | begin <text>, | exclude <text>, and | include <text>. The
include modifier limits output to lines that contain the specified text, the exclude modifier
excludes any lines with the specified text, and the begin modifier displays the first line of
output with the specified text and all lines thereafter.
For specific instructions and examples regarding these modifiers, refer to the introduction
of the Enable Mode Command Set on page
Syntax Description
<interface>
vlan <vlan id>
Default Values
No default values are necessary for this command.
Command History
Release 5.1
Release 17.1
60000CRG0-35E
Shows information for a specific interface type. Specify an interface in the
format <interface type [slot/port | slot/port.subinterface id | interface id |
interface id.subinterface id | ap | ap/radio | ap/radio.vap]>. For example, for
a T1 interface, use t1 0/1; for an Ethernet subinterface, use eth 0/1.1; for a
PPP interface, use ppp 1; for an ATM subinterface, use atm 1.1; and for a
wireless virtual access point, use dot11ap 1/1.1. Type show mac
address-table interface ? for a list of valid interfaces.
Optional. Shows address-table information related to a specific virtual local
area network (VLAN). Valid range is 1 to 4094.
Command was introduced.
Command was expanded to include the modifiers begin, exclude, and
include.
Copyright © 2012 ADTRAN, Inc.
Enable Mode Command Set
83.
664