ADTRAN AOS Version R10.1.0 Command Reference Manual page 718

Command Reference Guide
show route-map
Use the show route-map command to display any route maps that have been configured in the router. This
command displays any match and set clauses associated with the route map, as well as the number of
incoming routes that have matched each route map. Route maps can be used for Border Gateway Protocol
(BGP) and PBR. Variations of this command include:
show route-map
show route-map <name>
The output of all show commands can be limited by appending the following modifiers to
the end of the command: | begin <text>, | exclude <text>, and | include <text>. The
include modifier limits output to lines that contain the specified text, the exclude modifier
excludes any lines with the specified text, and the begin modifier displays the first line of
output with the specified text and all lines thereafter.
For specific instructions and examples regarding these modifiers, refer to the introduction
of the Enable Mode Command Set on page
Syntax Description
<name>
Default Values
By default, this command displays all defined route maps.
Command History
Release 10.1
Release 17.1
Usage Examples
In the example below, all route maps in the router are displayed.
>enable
#show route-map
route-map RouteMap1, permit, sequence 10
Match clauses:
community (community-list filter): CommList1
Set clauses:
local-preference 250
BGP Filtering matches: 75 routes
Policy routing matches: 0 packets 0 bytes
route-map RouteMap1, permit, sequence 20
Match clauses:
community (community-list filter): CommList2
60000CRG0-35E
Optional. Displays only the route map matching the specified name.
Command was introduced.
Command was expanded to include the modifiers begin, exclude, and
include.
Copyright © 2012 ADTRAN, Inc.
Enable Mode Command Set
83.
718