ADTRAN AOS Version R10.1.0 Command Reference Manual page 342

Command Reference Guide
debug ping twamp
Use the debug ping twamp command to activate debug messages associated with Two-Way Active
Measurement Protocol (TWAMP) ping activity. Debug messages are displayed (real time) on the terminal
(or Telnet) screen. Use the no form of this command to disable the debug messages. Variations of this
command include:
debug ping twamp
debug ping twamp control
debug ping twamp control events
debug ping twamp control packets
debug ping twamp test
debug ping twamp test events
debug ping twamp test packets
Turning on a large amount of debug information can adversely affect the performance of
your unit.
Syntax Description
control
events
packets
test
events
packets
Default Values
By default, all debug messages in AOS are disabled.
Command History
Release 17.6
Usage Examples
The following example enables debug messaging for TWAMP control events and messages:
>enable
#debug ping twamp control
Type CTRL+C to abort. Test will complete in approximately 7 seconds.
2009.06.03 11:18:51 IP.TWPING CTRL EVNT Attempting to connect
2009.06.03 11:18:51 IP.TWPING CTRL EVNT State changed Init -> Opening (event=Open Connection)
2009.06.03 11:18:51 IP.TWPING CTRL EVNT State changed Opening -> Setup (event=RX
60000CRG0-35E
Optional. Activates TWAMP control debug messages.
Optional. Displays TWAMP control events and messages.
Optional. Displays TWAMP control events and packets.
Activates TWAMP Test debug messages.
Optional. Displays TWAMP test events and messages.
Optional. Displays TWAMP test events and packets.
Command was introduced.
Copyright © 2012 ADTRAN, Inc.
Enable Mode Command Set
342