ADTRAN AOS Version R10.1.0 Command Reference Manual page 895

Command Reference Guide
auto-link
Use the auto-link command to enable the auto-link feature and to specify the communication method
between an AOS device and the n-Command
can be either via Hypertext Transfer Protocol (HTTP) or Hypertext Transfer Protocol over Secure Socket
Layer (HTTPS). Auto-link allows a client device to connect to an ADTRAN n-Command
management appliance. Use the no form of this command to disable auto-link or to return to the default
communication method. Variations of this command include:
auto-link
auto-link http
auto-link https
Syntax Description
http
https
Default Values
By default, auto-link is disabled. By default, auto-link uses HTTPS.
Command History
Release 17.3/A1
Functional Notes
The n-Command client must first be configured and enabled before the n-Command MSP server can be
contacted. The n-Command MSP server is a network management appliance that enables auto-discovery
of the AOS unit and provides a central management solution for configuration changes, firmware updates,
and basic monitoring. Without enabling auto-link, the client will not be detected by the server. For more
information about configuring the auto-link feature, refer to the configuration guide Configuring Auto-Link
for AOS and n-Command MSP (article number 3098) available online at https://supportforums.adtran.com.
Usage Examples
The following example enables auto-link:
(config)#auto-link
The following example specifies that the client use HTTP to communicate with the server:
(config)#auto-link http
60000CRG0-35E
managed service provider (MSP) server. Communication
®
Specifies that the client use the HTTP posting method.
Specifies that the client use the HTTPS posting method.
Command was introduced.
Copyright © 2012 ADTRAN, Inc.
Global Configuration Mode Command Set
MSP network
®
895