Show Ip Flow - ADTRAN AOS Version R10.1.0 Command Reference Manual

Command Reference Guide

show ip flow

Use the show ip flow command to display information regarding the configuration of integrated traffic
monitoring (ITM) on your AOS product. Variations of this command include:
show ip flow cache
show ip flow export
show ip flow interface
The output of all show commands can be limited by appending the following modifiers to
the end of the command: | begin <text>, | exclude <text>, and | include <text>. The
include modifier limits output to lines that contain the specified text, the exclude modifier
excludes any lines with the specified text, and the begin modifier displays the first line of
output with the specified text and all lines thereafter.
For specific instructions and examples regarding these modifiers, refer to the introduction
of the Enable Mode Command Set on page
Syntax Description
cache
export
interface
Default Values
No default values are necessary for this command.
Command History
Release 16.1
Release 17.1
Usage Examples
The following is sample output from the show ip flow export command:
#show ip flow export
Traffic Flow export is ENABLED
Version: 9
Export Destinations
10.22.16.132: 9991
vrf BLUE
source ppp 1
10.5.22.203: 30000
11 flows exported in 8 udp datagrams
0 flows failed to export
60000CRG0-35E
Displays a summary of the current state of the cache of nonexpired traffic
flows.
Displays information on export packets sent to a destination.
Displays the ITM configuration of each interface on the router.
Command was introduced.
Command was expanded to include the modifiers begin, exclude, and
include.
Copyright © 2012 ADTRAN, Inc.
Enable Mode Command Set
83.
552