ADTRAN AOS Version R10.1.0 Command Reference Manual page 1061

Command Reference Guide
ip policy-class <ipv4 acp name> max-sessions <number>
Use the ip policy-class max-sessions command to specify the number of allowed sessions for an Internet
Protocol version 4 (IPv4) access control policy (ACP). For more details on IPv4 ACP functionality in
AOS, refer to the IPv4 Access Control Policy Command Set on page
command to return to the default value.
Syntax Description
<ipv4 acp name>
<number>
Default Values
By default, all AOS security features are disabled and there are no configured ACP entries.
Command History
Release 2.1
Functional Notes
To set the system-wide maximum limit for ACP sessions (both IPv4 and IPv6), use the command
policy-class max-sessions <number> on page
the command ipv6 policy-class <ipv6 acp name> max-sessions <number> on page
Usage Examples
The following example allows no more than 100 IPv4 policy sessions on the ACP named PRIVATE:
(config)#ip policy-class PRIVATE max-sessions 100
The following example restores the default policy sessions limit on the ACP named PRIVATE:
(config)#no ip policy-class PRIVATE max-sessions
60000CRG0-35E
Identifies the configured IPv4 ACP using an alphanumeric descriptor
(maximum of 50 characters). All ACP descriptors are case sensitive.
Specifies the maximum number of allowed policy sessions for the named
IPv4 ACP.
This number must be within the appropriate range limits. The limits depend
on the type of AOS device being used. Setting this value to 0 restores the
default setting. When setting the max-sessions for all IPv4 ACPs, this
default is determined at boot time based on the amount of memory
available. For a named IPv4 ACP, this default is one-third of the total
number of allowed ACP sessions.
Command was introduced.
1282. To set the maximum limit for IPv6 ACP sessions, use
Copyright © 2012 ADTRAN, Inc.
Global Configuration Mode Command Set
3144. Use the no form of this
1216.
1061