ADTRAN AOS Version R10.1.0 Command Reference Manual page 515

Command Reference Guide
show hw-access-list
Use the show hw-access-list command to display hardware access control list (ACL) configuration and
statistics. Variations of this command include:
show hw-access-list
show hw-access-list <name>
The output of all show commands can be limited by appending the following modifiers to
the end of the command: | begin <text>, | exclude <text>, and | include <text>. The
include modifier limits output to lines that contain the specified text, the exclude modifier
excludes any lines with the specified text, and the begin modifier displays the first line of
output with the specified text and all lines thereafter.
For specific instructions and examples regarding these modifiers, refer to the introduction
of the Enable Mode Command Set on page
Syntax Description
<name>
Default Values
No default values are necessary for this command.
Command History
Release 17.6
Functional Notes
The show hw-access-list command displays all configured hardware ACLs in the system. All entries in
the ACL are displayed, and a counter indicating the number of frames matching the entry is listed.
Usage Examples
The following is sample output from the show hw-access-list <name> command, using the hardware
ACL NET135:
>enable
#show hw-access-list NET135
Extended IP hardware access list NET135
permit ip 10.22.135.0 0.0.0.255 any
permit ip any 10.22.135.0 0.0.0.255
60000CRG0-35E
Optional. Specifies a particular hardware ACL to display.
Command was introduced.
log (302 matches)
log (279 matches)
Copyright © 2012 ADTRAN, Inc.
Enable Mode Command Set
83.
515