Show File - ADTRAN AOS Version R10.1.0 Command Reference Manual

Command Reference Guide

show file

Use the show file command to display a specified file to the terminal screen. Variations of this command
include:
show file <filename>
show file <filename> checksum
show file cflash <filename>
show file cflash <filename> checksum
show file flash <filename>
show file flash <filename> checksum
show file ramdisk <filename>
show file ramdisk <filename> checksum
show file usbdrive0 <filename>
show file usbdrive0 <filename> checksum
The output of all show commands can be limited by appending the following modifiers to
the end of the command: | begin <text>, | exclude <text>, and | include <text>. The
include modifier limits output to lines that contain the specified text, the exclude modifier
excludes any lines with the specified text, and the begin modifier displays the first line of
output with the specified text and all lines thereafter.
For specific instructions and examples regarding these modifiers, refer to the introduction
of the Enable Mode Command Set on page
To display files located in the flash memory on products with CompactFlash
the flash keyword must be specified whether or not a CompactFlash card is installed.
Not all units are capable of using a RAM disk file system or have a CompactFlash card
installed. Use the show file ? command to display a list of valid commands at the enable
prompt.
The contents of the file are displayed only if the file is less than 300 kilobytes.
The checksum is displayed only if the file is less than 500 kilobytes.
Syntax Description
<filename>
cflash
checksum
flash
60000CRG0-35E
Displays information on the specified file. Wildcard entries (such as *.biz)
are not valid for the show file command.
Specifies a file located in CompactFlash memory.
Optional. Displays the message digest 5 (MD5) checksum of the specified
file.
Specifies a file located in flash memory.
Copyright © 2012 ADTRAN, Inc.
Enable Mode Command Set
83.
®
capability,
497