Command Reference Guide
show dial-backup interfaces
Use the show dial-backup interfaces command to display all configured dial-backup interfaces and the
associated parameters for each.
The output of all show commands can be limited by appending the following modifiers to
the end of the command: | begin <text>, | exclude <text>, and | include <text>. The
include modifier limits output to lines that contain the specified text, the exclude modifier
excludes any lines with the specified text, and the begin modifier displays the first line of
output with the specified text and all lines thereafter.
For specific instructions and examples regarding these modifiers, refer to the introduction
of the
Enable Mode Command Set on page
Syntax Description
No subcommands.
Default Values
No default values are necessary for this command.
Command History
Release 1.1
Release 5.1
Release 17.1
Usage Examples
The following example enters the Enable mode and uses the show command to display dial-backup
interface information:
>enable
#show dial-backup interfaces
Dial-backup interfaces...
fr 1.16 backup interface:
Backup state: idle
Backup protocol: PPP
Call mode: originate
Auto-backup: enabled
Auto-restore: enabled
Priority: 50
Backup delay: 10 seconds
Restore delay: 10 seconds
Connect timeout: 60 seconds
--MORE--
60000CRG0-35E
Command was introduced.
Command was expanded to include the Point-to-Point Protocol (PPP) dial
backup.
Command was expanded to include the modifiers begin, exclude, and
include.
Copyright © 2012 ADTRAN, Inc.
Enable Mode Command Set
83.
472