ADTRAN AOS Version R10.1.0 Command Reference Manual page 588

Command Reference Guide
show ip prefix-list
Use the show ip prefix-list command to display Border Gateway Protocol (BGP) prefix list information.
Variations of this command include:
show ip prefix-list <name>
show ip prefix-list detail <name>
show ip prefix-list summary <name>
The output of all show commands can be limited by appending the following modifiers to
the end of the command: | begin <text>, | exclude <text>, and | include <text>. The
include modifier limits output to lines that contain the specified text, the exclude modifier
excludes any lines with the specified text, and the begin modifier displays the first line of
output with the specified text and all lines thereafter.
For specific instructions and examples regarding these modifiers, refer to the introduction
of the Enable Mode Command Set on page
Syntax Description
<name>
detail
summary
Default Values
No default values are necessary for this command.
Command History
Release 8.1
Release 17.1
Functional Notes
If the show ip prefix-list command is issued with no arguments, a listing of the prefix-list rules, but no hit
count statistics, is displayed.
Usage Examples
The following example displays information about the prefix list test.
>enable
#show ip prefix-list test
ip prefix-list test: 4 entries
seq 5 permit 0.0.0.0/0 ge 8 le 8
seq 10 deny 0.0.0.0/0 ge 9 le 9
seq 15 permit 0.0.0.0/0 ge 10 le 10
seq 20 deny 0.0.0.0/0 ge 11
60000CRG0-35E
Shows information for a specific prefix list.
Optional. Shows a listing of the prefix list rules and their hit counts.
Optional. Shows information about the entire prefix list.
Command was introduced.
Command was expanded to include the modifiers begin, exclude, and
include.
Copyright © 2012 ADTRAN, Inc.
Enable Mode Command Set
83.
588