ADTRAN AOS Version R10.1.0 Command Reference Manual page 660

Command Reference Guide
show mac address-table aging-time
Use the show mac address-table aging-time command to display information regarding the amount of
time dynamic entries remain in the medium access control (MAC) address table.
The output of all show commands can be limited by appending the following modifiers to
the end of the command: | begin <text>, | exclude <text>, and | include <text>. The
include modifier limits output to lines that contain the specified text, the exclude modifier
excludes any lines with the specified text, and the begin modifier displays the first line of
output with the specified text and all lines thereafter.
For specific instructions and examples regarding these modifiers, refer to the introduction
of the Enable Mode Command Set on page
Syntax Description
No subcommands.
Default Values
No default values are necessary for this command.
Command History
Release 5.1
Release 17.1
Usage Examples
The following is sample output from the show mac address-table aging-time command for a switch
configured with an address-table aging-time:
>enable
#show mac address-table aging-time
Aging Time
----------------
300 Seconds
60000CRG0-35E
Command was introduced.
Command was expanded to include the modifiers begin, exclude, and
include.
Copyright © 2012 ADTRAN, Inc.
Enable Mode Command Set
83.
660