ADTRAN AOS Version R10.1.0 Command Reference Manual page 406

Command Reference Guide
ramdisk <size>
Use the ramdisk command to create a volatile RAM disk file system and allocate memory in bytes to the
newly created RAM disk. Use the no form of this command to delete the RAM disk.
Not all units are capable of using a RAM disk file system. Use the ? command to display a
list of valid commands at the enable prompt.
Syntax Description
<size>
Default Values
No default values are necessary for this command.
Command History
Release 17.7
Usage Examples
The following example creates a volatile RAM disk file system and allocates 128000 bytes of memory:
>enable
#ramdisk 128000
The following example creates a volatile RAM disk file system and uses the multiplier k to allocate 131072
bytes of memory (where 128k is 128 x 1024 = 131072):
>enable
#ramdisk 128k
60000CRG0-35E
Specifies the size of the RAM disk in bytes. Valid range is 65536 to the
maximum available heap size on the unit. Input for this value allows the use
of the following characters as multipliers: M, m, K, and k.
Command was introduced.
Copyright © 2012 ADTRAN, Inc.
Enable Mode Command Set
406