ADTRAN AOS Version R10.1.0 Command Reference Manual page 1151

Command Reference Guide
ip sip proxy sip-server primary
Use the ip sip proxy sip-server primary command to configure the primary Session Initiation Protocol
(SIP) server softswitch. Use the no form of this command to disable the softswitch. The softswitch cannot
be disabled unless all configured secondary softswitches are removed (refer to the command
sip-server secondary on page
ip sip proxy sip-server primary <hostname | ip address>
ip sip proxy sip-server primary <hostname | ip address> tcp
ip sip proxy sip-server primary <hostname | ip address> tcp <port>
ip sip proxy sip-server primary <hostname | ip address> udp
ip sip proxy sip-server primary <hostname | ip address> udp <port>
Syntax Description
<hostname | ip address>
tcp
udp
<port>
Default Values
By default, no softswitches are configured. If a softswitch is configured, the default protocol is UDP on port
5060. If a particular protocol is configured and no port is specified, the default port is set to 5060.
Command History
Release 16.1
Functional Notes
The guidelines for configuring the softswitch(es) depend on the mode of operation selected. Softswitch
configuration is always needed for Stateful mode. It is only needed for Outbound mode and Transparent
mode when the SIP Request does not contain any fields that can be resolved to the softswitch's location.
If a host name is used to specify the outbound SIP proxy server, a domain naming system (DNS) server
must be configured on the AOS unit using the command
dynamic IP interface.
Usage Examples
The following example sets the primary softswitch:
(config)#ip sip proxy sip-server primary 208.61.209.1
60000CRG0-35E
1152). Variations of this command include:
Specifies the fully qualified domain name (FQDN) or IP address of the
outbound SIP proxy server. IP addresses should be expressed in dotted
decimal notation (for example, 208.61.209.1).
Optional. Configures the softswitch to use Transmission Control Protocol
(TCP).
Optional. Configures the softswitch to use User Datagram Protocol (UDP).
Optional. Specifies the TCP or UDP port used by the softswitch. Range is 1
to 65535.
Command was introduced.
Copyright © 2012 ADTRAN, Inc.
Global Configuration Mode Command Set
name-server on page 1270
ip sip proxy
or learned via a
1151