ADTRAN AOS Version R10.1.0 Command Reference Manual page 797

Command Reference Guide
show voice line
Use the show voice line command to display voice line stations. Variations of this command include:
show voice line
show voice line <station>
The output of all show commands can be limited by appending the following modifiers to
the end of the command: | begin <text>, | exclude <text>, and | include <text>. The
include modifier limits output to lines that contain the specified text, the exclude modifier
excludes any lines with the specified text, and the begin modifier displays the first line of
output with the specified text and all lines thereafter.
For specific instructions and examples regarding these modifiers, refer to the introduction
of the Enable Mode Command Set on page
Syntax Description
<station>
Default Values
No default values are necessary for this command.
Command History
Release 15.1
Release 17.1
Usage Examples
The following example shows sample output from the show voice line command:
>enable
#show voice line
Line: 4444
Trunk: not configured
Registered Endpoints: 0
Call State: IDLE
Active Endpoints: N/A
DSP Resource: N/A
Line: Sales
Trunk: not configured
Registered Endpoints: 0
Call state: IDLE
--MORE--
60000CRG0-35E
Optional. Displays a specific voice line station name or extension on the
system base on the valid voice line descriptors entered into the system.
Command was introduced.
Command was expanded to include the modifiers begin, exclude, and
include.
Copyright © 2012 ADTRAN, Inc.
Enable Mode Command Set
83.
797