ADTRAN AOS Version R10.1.0 Command Reference Manual page 263

Command Reference Guide
debug frame-relay multilink
Use the debug frame-relay multilink command to activate debug messages associated with Frame Relay
multilink operation. Debug messages are displayed (real time) to the terminal (or Telnet) screen. Use the
no form of this command to disable the debug messages. Variations of this command include:
debug frame-relay multilink
debug frame-relay multilink <interface>
debug frame-relay multilink states
Turning on a large amount of debug information can adversely affect the performance of
your unit.
Syntax Description
<interface>
states
Default Values
By default, all debug messages in AOS are disabled.
Command History
Release 9.1
Usage Examples
The following example activates debug messages associated with multilink operation for all Frame Relay
interfaces:
>enable
#debug frame-relay multilink
60000CRG0-35E
Optional. Activates debug messages for the specified interface. Specify an
interface in the format <interface type [slot/port | slot/port.subinterface id |
interface id | interface id.subinterface id | ap | ap/radio | ap/radio.vap]>. For
example, for a T1 interface, use t1 0/1; for an Ethernet subinterface, use
eth 0/1.1; for a PPP interface, use ppp 1; for an ATM subinterface, use
atm 1.1; and for a wireless virtual access point, use dot11ap 1/1.1. Type
debug frame-relay multilink ? for a complete list of applicable interfaces.
Optional. Activates the debug messages for Link Integrity Protocol (LIP).
Command was introduced.
Copyright © 2012 ADTRAN, Inc.
Enable Mode Command Set
263