ADTRAN AOS Version R10.1.0 Command Reference Manual page 794

Command Reference Guide
show voice door-phone
Use the show voice door-phone command to display the door phone account settings. A door phone is
used to communicate with visitors prior to them entering an establishment.
The output of all show commands can be limited by appending the following modifiers to
the end of the command: | begin <text>, | exclude <text>, and | include <text>. The
include modifier limits output to lines that contain the specified text, the exclude modifier
excludes any lines with the specified text, and the begin modifier displays the first line of
output with the specified text and all lines thereafter.
For specific instructions and examples regarding these modifiers, refer to the introduction
of the Enable Mode Command Set on page
Syntax Description
No subcommands.
Default Values
No default values are necessary for this command.
Command History
Release 12.1
Release 17.1
Usage Examples
The following example shows sample output from the show voice door-phone command:
>enable
#show voice door-phone
First Last Ext
-------------------------------------------------------------------------------------
Front Door 4430
60000CRG0-35E
Command was introduced.
Command was expanded to include the modifiers begin, exclude, and
include.
Interface Description
virtual Front Door of Building
Copyright © 2012 ADTRAN, Inc.
Enable Mode Command Set
83.
794