Show Lldp - ADTRAN AOS Version R10.1.0 Command Reference Manual

Command Reference Guide

show lldp

Use the show lldp command to display the Link Layer Discovery Protocol (LLDP) transmit interval and
transmitted time to live (TTL).
The output of all show commands can be limited by appending the following modifiers to
the end of the command: | begin <text>, | exclude <text>, and | include <text>. The
include modifier limits output to lines that contain the specified text, the exclude modifier
excludes any lines with the specified text, and the begin modifier displays the first line of
output with the specified text and all lines thereafter.
For specific instructions and examples regarding these modifiers, refer to the introduction
of the Enable Mode Command Set on page
Syntax Description
No subcommands.
Default Values
No default values are necessary for this command.
Command History
Release 8.1
Release 17.1
Functional Notes
The TTL is calculated by multiplying the transmit interval by the TTL multiplier. For more information, refer
to the command lldp on page
Usage Examples
The following is sample output for the LLDP timer configuration:
>enable
#show lldp
Global LLDP information:
Sending LLDP packets every 30 seconds
Sending TTL of 120 seconds
60000CRG0-35E
Command was introduced.
Command was expanded to include the modifiers begin, exclude, and
include.
1233.
Copyright © 2012 ADTRAN, Inc.
Enable Mode Command Set
83.
648