Show Gvrp Configuration - ADTRAN AOS Version R10.1.0 Command Reference Manual

Command Reference Guide

show gvrp configuration

Use the show gvrp configuration command to show a GARP VLAN Registration Protocol (GVRP)
configuration summary for the switch.
The output of all show commands can be limited by appending the following modifiers to
the end of the command: | begin <text>, | exclude <text>, and | include <text>. The
include modifier limits output to lines that contain the specified text, the exclude modifier
excludes any lines with the specified text, and the begin modifier displays the first line of
output with the specified text and all lines thereafter.
For specific instructions and examples regarding these modifiers, refer to the introduction
of the Enable Mode Command Set on page
Syntax Description
No subcommands.
Default Values
No default values are necessary for this command.
Command History
Release 8.1
Release 17.1
Usage Examples
The following example displays a GVRP configuration summary for the switch:
>enable
#show gvrp configuration
Global GVRP Configuration:
GVRP Feature is currently enabled globally.
GVRP Timers (milliseconds)
Join 200
Leave 600
LeaveAll 20000
Port based GVRP Configuration:
GVRP enabled ports
----------------------------------------------------
eth 0/24
#
60000CRG0-35E
Command was introduced.
Command was expanded to include the modifiers begin, exclude, and
include.
Copyright © 2012 ADTRAN, Inc.
Enable Mode Command Set
83.
507