ADTRAN AOS Version R10.1.0 Command Reference Manual page 575

Command Reference Guide
show ip pim-sparse
Use the show ip pim-sparse command to display protocol-independent multicast (PIM) configuration
information. Sparse mode or PIM-SM is a routing protocol used to establish and maintain the multicast
distribution tree. Routers can participate in the shared tree (RPT) rooted at the rendezvous point (RP)
router or the shortest path tree (SPT) rooted at a multicast source. PIM-SM also establishes both shared
trees and SPTs. Variations of this command include:
show ip pim-sparse
show ip pim-sparse interfaces <interface>
show ip pim-sparse neighbor
show ip pim-sparse rp-map
show ip pim-sparse rp-set
show ip pim-sparse state
show ip pim-sparse traffic
The output of all show commands can be limited by appending the following modifiers to
the end of the command: | begin <text>, | exclude <text>, and | include <text>. The
include modifier limits output to lines that contain the specified text, the exclude modifier
excludes any lines with the specified text, and the begin modifier displays the first line of
output with the specified text and all lines thereafter.
For specific instructions and examples regarding these modifiers, refer to the introduction
of the Enable Mode Command Set on page
Syntax Description
interfaces <interface>
neighbor
rp-map
rp-set
state
traffic
Default Values
No default values are necessary for this command.
60000CRG0-35E
Optional. Displays PIM-SM configuration and status information for a
specific interface. Specify an interface in the format <interface type [slot/port
| slot/port.subinterface id | interface id | interface id.subinterface id | ap |
ap/radio | ap/radio.vap]>. For example, for a T1 interface, use t1 0/1; for an
Ethernet subinterface, use eth 0/1.1; for a PPP interface, use ppp 1; for an
ATM subinterface, use atm 1.1; and for a wireless virtual access point, use
dot11ap 1/1.1. Type show ip pim-sparse interface ? to display a list of
applicable interfaces.
Optional. Displays neighbor adjacency information.
Optional. Displays active group-to-RP mappings.
Optional. Displays a list of statically configured RP candidates. The
multicast group IP address is 224.0.0.0 /4 when no access group was
applied to the rp-address command (refer to
page 3018). Otherwise, it is the name of the access group.
Optional. Displays multicast route PIM state information.
Optional. Displays active PIM-SM control traffic statistics.
Copyright © 2012 ADTRAN, Inc.
Enable Mode Command Set
83.
rp-address <ip address> on
575