ADTRAN AOS Version R10.1.0 Command Reference Manual page 1152

Command Reference Guide
ip sip proxy sip-server secondary
Use the ip sip proxy sip-server secondary command to configure the secondary Session Initiation
Protocol (SIP) softswitch. This command can be entered multiple times to specify numerous secondary
softswitches. Use the no form of this command to disable this feature. Variations of this command include:
ip sip proxy sip-server secondary <hostname | ip address>
ip sip proxy sip-server secondary <hostname | ip address> tcp
ip sip proxy sip-server secondary <hostname | ip address> tcp <port>
ip sip proxy sip-server secondary <hostname | ip address> udp
ip sip proxy sip-server secondary <hostname | ip address> udp <port>
Syntax Description
<hostname | ip address>
tcp
udp
<port>
Default Values
By default, no softswitches are configured. If a softswitch is configured, the default protocol is UDP on port
5060. If a particular protocol is configured and no port is specified, the default port is set to 5060.
Command History
Release 16.1
Functional Notes
The guidelines for configuring the softswitch(es) depend on the mode of operation selected. Softswitch
configuration is always needed for Stateful mode. It is only needed for Outbound mode and Transparent
mode when the SIP Request does not contain any fields that can be resolved to the softswitch's location.
When disabling softswitches, all secondary softswitches must be removed before the primary softswitch
can be removed.
If a host name is used to specify the outbound SIP proxy server, a domain naming system (DNS) server
must be configured on the AOS unit using the command
dynamic IP interface.
Usage Examples
The following example sets the secondary softswitch:
(config)#ip sip proxy sip-server secondary 208.61.209.2
60000CRG0-35E
Specifies the fully qualified domain name (FQDN) or IP address of the
outbound SIP proxy server. IP addresses should be expressed in dotted
decimal notation (for example, 208.61.209.2).
Optional. Configures the softswitch to use Transmission Control Protocol
(TCP).
Optional. Configures the softswitch to use User Datagram Protocol (UDP).
Optional. Specifies the TCP or UDP port used by the softswitch. Range is 1
to 65535.
Command was introduced.
Copyright © 2012 ADTRAN, Inc.
Global Configuration Mode Command Set
name-server on page 1270 or learned via a
1152