ADTRAN AOS Version R10.1.0 Command Reference Manual page 211

Command Reference Guide
tftp
usbdrive0
xmodem
Default Values
No default values are necessary for this command.
Command History
Release 8.1
Release 16.1
Release 17.7
Release 18.2
Usage Examples
The following example copies the startup configuration file to the current running configuration:
>enable
#copy startup-config running-config
Opening and applying file...
Any changes made to the current running configuration of the AOS unit that have not been
saved to the startup configuration file (using the write command) will be lost when the
copy startup-config running-config command is entered.
The following example copies the startup configuration (located in flash memory) to CompactFlash and
names the file config_01.txt:
>enable
#copy startup-config cflash config_01.txt
Percent Complete 100%
#
60000CRG0-35E
Copies the current startup configuration to a specified Trivial File Transfer
Protocol (TFTP) server.
After entering copy startup-config tftp, AOS prompts for the following
information:
Address of remote host:
Destination filename:
Copies the startup configuration and saves it to the USB flash drive memory
using the specified file name.
Copies the current startup configuration (using the XMODEM protocol) to
the terminal connected to the console port. XMODEM capability is provided
in VT100 terminal emulation software, such as HyperTerminal.
Command was introduced.
Command was expanded to include HTTP and HTTPS.
Command was expanded to include the ramdisk parameter.
Command was expanded to include USB flash drive memory.
Copyright © 2012 ADTRAN, Inc.
Enable Mode Command Set
Specifies the IP address of the TFTP server.
Specifies the file name to use when storing the
copied file on the TFTP server. (The file will be
placed in the default directory established by the
TFTP server.)
211