Table of Contents
Advertisement
Command Reference Guide
ip urlfilter server <ip address>
Use the ip urlfilter server command to identify a uniform resource locator (URL) filter server by IP
address and port number. Use the no form of this command to remove the server from use. Variations of
this command include:
ip urlfilter server <ip address>
ip urlfilter server <ip address> port <number>
ip urlfilter server <ip address> timeout <value>
Syntax Description
<ip address>
port <number>
timeout <value>
Default Values
By default, there are no URL filtering servers configured. When configuring a URL filtering server, the port
default is 15,868, and the timeout default is 5 seconds.
Command History
Release 12.1
Usage Examples
The following example identifies a URL filtering server at IP address 10.1.1.1 that listens for URL filtering
requests on port 15,868 (default) and waits for a response for 10 seconds before determining that the
filtering server is down:
(config)#ip urlfilter server 10.1.1.1 timeout 10
60000CRG0-35E
Specifies the server IP address. IP addresses should be expressed in
dotted decimal notation (for example, 10.10.10.1).
Specifies the server Transmission Control Protocol (TCP) port number that
will receive requests.
Specifies the number of seconds to wait for a response from the URL
filtering server before determining that it is out of service. Range is 1 to
300 seconds.
Command was introduced.
Copyright © 2012 ADTRAN, Inc.
Global Configuration Mode Command Set
1179
Advertisement
Table of Contents
