ADTRAN AOS Version R10.1.0 Command Reference Manual page 771

Command Reference Guide
show timing-domain
Use the show timing-domain command to display the system timing domains.
The output of all show commands can be limited by appending the following modifiers to
the end of the command: | begin <text>, | exclude <text>, and | include <text>. The
include modifier limits output to lines that contain the specified text, the exclude modifier
excludes any lines with the specified text, and the begin modifier displays the first line of
output with the specified text and all lines thereafter.
For specific instructions and examples regarding these modifiers, refer to the introduction
of the Enable Mode Command Set on page
Syntax Description
No subcommands.
Default Values
No default values are necessary for this command.
Command History
Release A5.01
Usage Examples
The following is sample output from the show timing-domain command:
>enable
#show timing-domain
Timing Domain Source Config Table
Domain Interface
1 t1 0/1
1 t1 0/2
2 t1 0/3
2 t1 0/4
Timing Domain System Config Table
Domain: 1 Active Source: System
Primary Interface
t1 0/1
Secondary Interface
60000CRG0-35E
Command was introduced.
Config Source
Primary Line
None System
None System
Primary Line
Source Status
t1 0/1 Alarm
Source Status
Copyright © 2012 ADTRAN, Inc.
Enable Mode Command Set
83.
Status
Alarm
Available
Available
Alarm
771