ADTRAN AOS Version R10.1.0 Command Reference Manual page 627

Command Reference Guide
show ipv6 dhcp interface
Use the show ipv6 dhcp interface command to display the Dynamic Host Control Protocol version 6
(DHCPv6) mode and settings for interfaces configured for DHCPv6. Variations of this command include:
show ipv6 dhcp interface <interface>
show ipv6 dhcp interface <interface> summary
The output of all show commands can be limited by appending the following modifiers to
the end of the command: | begin <text>, | exclude <text>, and | include <text>. The
include modifier limits output to lines that contain the specified text, the exclude modifier
excludes any lines with the specified text, and the begin modifier displays the first line of
output with the specified text and all lines thereafter.
For specific instructions and examples regarding these modifiers, refer to the introduction
of the Enable Mode Command Set on page
Syntax Description
<interface>
summary
Default Values
No default values necessary for this command.
Command History
Release R10.1.0
Usage Examples
The following example displays the DHCPv6 mode and settings for the eth 0/1 interface:
>enable
#show ipv6 dhcp interface eth 0/1
!
interface Ethernet 0/1
ipv6
ipv6 nd ra suppress
ipv6 address dhcp
ipv6 dhcp client pd prefix1
60000CRG0-35E
Specifies the interface for which to display DHCPv6 settings. Specify
interfaces in the format <interface type [slot/port | slot/port.subinterface id |
interface id | interface id.subinterface id>. For example, to specify a
Point-to-Point Protocol (PPP) interface, enter ppp 1. Enter show ipv6 dhcp
interface ? for a list of available interfaces.
Optional. Summarizes the command output.
Command was introduced.
Copyright © 2012 ADTRAN, Inc.
Enable Mode Command Set
83.
627