ADTRAN AOS Version R10.1.0 Command Reference Manual page 518

Command Reference Guide
show hw-filter-resource
Use the show hw-filter-resource command to display the used and available hardware filter resources.
This information is valuable when making changes to configured hardware access control lists (ACLs) and
hardware access maps. For more information on hardware ACLs and access maps, refer to the
ACL and Access Map Command Set on page
The output of all show commands can be limited by appending the following modifiers to
the end of the command: | begin <text>, | exclude <text>, and | include <text>. The
include modifier limits output to lines that contain the specified text, the exclude modifier
excludes any lines with the specified text, and the begin modifier displays the first line of
output with the specified text and all lines thereafter.
For specific instructions and examples regarding these modifiers, refer to the introduction
of the Enable Mode Command Set on page
Syntax Description
No subcommands.
Default Values
No default values are necessary for this command.
Command History
Release 17.6
Functional Notes
Changing hardware ACL or hardware access map configuration or application causes new information to
be reinstalled on the hardware. It is possible to run out of hardware resources depending on how many
resources are needed to apply the desired change. If there are not enough hardware resources to install
the new criteria, an error message is displayed.
Usage Examples
The following is sample output from the show hw-filter-resource command:
>enable
#show hw-filter-resource
Total Rules: 512
Rules Used: 128
60000CRG0-35E
3109.
Command was introduced.
Copyright © 2012 ADTRAN, Inc.
Enable Mode Command Set
83.
Hardware
518