ADTRAN AOS Version R10.1.0 Command Reference Manual page 1094

Command Reference Guide
ip rtp quality-monitoring threshold jitter
Use the ip rtp quality-monitoring threshold jitter command to specify the threshold values for logging
jitter events during voice quality monitoring (VQM). When more jitter is detected in the Realtime
Transport Protocol (RTP) than the specified event threshold, an event message is generated. Use the no
form of this command to disable the event reporting for that message type and threshold. Variations of this
command include:
ip rtp quality-monitoring threshold jitter error
ip rtp quality-monitoring threshold jitter error <value>
ip rtp quality-monitoring threshold jitter info
ip rtp quality-monitoring threshold jitter info <value>
ip rtp quality-monitoring threshold jitter notice
ip rtp quality-monitoring threshold jitter notice <value>
ip rtp quality-monitoring threshold jitter warning
ip rtp quality-monitoring threshold jitter warning <value>
Syntax Description
error
info
notice
warning
<value>
Default Values
By default, the jitter logging thresholds are info 0, notice 250, warning 350, and error 450.
Command History
Release 17.1
Usage Examples
The following example enables VQM jitter warning messages to be logged if jitter occurs above 200 ms:
(config)#ip rtp quality-monitoring threshold jitter warning 200
60000CRG0-35E
Specifies the threshold for jitter error messages to be logged.
Specifies the threshold for jitter information messages to be logged.
Specifies the threshold for jitter notice messages to be logged.
Specifies the threshold for jitter warning messages to be logged.
Optional. The range is 0 to 30000.
Command was introduced.
Copyright © 2012 ADTRAN, Inc.
Global Configuration Mode Command Set
1094