ADTRAN AOS Version R10.1.0 Command Reference Manual page 668

Command Reference Guide
show mac address-table static
Use the show mac address-table static command to display all static medium access control (MAC)
addresses known by AOS. Variations of this command include the following:
show mac address-table static
show mac address-table static address <mac address>
show mac address-table static address <mac address> interface <interface>
show mac address-table static address <mac address> interface <interface> vlan <vlan id>
show mac address-table static address <mac address> vlan <vlan id>
show mac address-table static interface <interface>
show mac address-table static interface <interface> vlan <vlan id>
show mac address-table static vlan <vlan id>
The output of all show commands can be limited by appending the following modifiers to
the end of the command: | begin <text>, | exclude <text>, and | include <text>. The
include modifier limits output to lines that contain the specified text, the exclude modifier
excludes any lines with the specified text, and the begin modifier displays the first line of
output with the specified text and all lines thereafter.
For specific instructions and examples regarding these modifiers, refer to the introduction
of the Enable Mode Command Set on page
Syntax Description
address <mac address>
interface <interface>
vlan <vlan id>
Default Values
No default values are necessary for this command.
Command History
Release 5.1
Release 17.1
60000CRG0-35E
Optional. Specifies a valid 48-bit MAC address. MAC addresses should be
expressed in the following format xx:xx:xx:xx:xx:xx (for example,
00:A0:C8:00:00:01).
Optional. Shows information for a specific interface. Specify an interface in
the format <interface type [slot/port | slot/port.subinterface id | interface id |
interface id.subinterface id | ap | ap/radio | ap/radio.vap]>. For example, for
a T1 interface, use t1 0/1; for an Ethernet subinterface, use eth 0/1.1; for a
PPP interface, use ppp 1; for an ATM subinterface, use atm 1.1; and for a
wireless virtual access point, use dot11ap 1/1.1. Type show mac
address-table static interface ? for a list of valid interfaces.
Optional. Shows address-table information related to a specific virtual local
area network (VLAN). Valid range is 1 to 4094.
Command was introduced.
Command was expanded to include the modifiers begin, exclude, and
include.
Copyright © 2012 ADTRAN, Inc.
Enable Mode Command Set
83.
668