ADTRAN AOS Version R10.1.0 Command Reference Manual page 243

Command Reference Guide
debug dot11 client
Use the debug dot11 client command to enable all dot11 client debugging for the wireless access
controller (AC). Debugging can also be limited to clients on a specific access point (AP) interface. Debug
messages are displayed (real time) on the terminal (or Telnet) screen. Use the no form of this command to
disable the debug messages. Variations of this command include:
debug dot11 client
debug dot11 client interface dot11ap <ap interface>
Turning on a large amount of debug information can adversely affect the performance of
your unit.
Syntax Description
interface dot11ap <ap interface>
Default Values
By default, all debug messages in AOS are disabled.
Command History
Release 15.1
Usage Examples
The following example activates debug messages for clients on AP interface 1:
>enable
#debug dot11 client interface dot11ap 1
2006.12.23 19:47:04 Dot11 Client: AP(1) Radio(1) VAP(1)Rx associate command from AP for
00:40:96:AB:3B:5E.
2006.12.23 19:48:40 Dot11 Client: AP(1) Radio(1) VAP(1)Rx disassociate command from AP for
00:40:96:AB:3B:5E.
These debug messages were captured as a wireless client associated and then
disassociated with the AP.
60000CRG0-35E
Optional. Activates debug messages for the specified AP interface.
Range is 1 to 8.
Command was introduced.
Copyright © 2012 ADTRAN, Inc.
Enable Mode Command Set
243