Show Qos - ADTRAN AOS Version R10.1.0 Command Reference Manual

Command Reference Guide

show qos

Use the show qos command to display information regarding quality of service (QoS) and 802.1p class of
service (CoS) settings. Variations of this command include:
show qos cos-map
show qos dscp-cos
show qos interface <interface>
show qos queuing
The output of all show commands can be limited by appending the following modifiers to
the end of the command: | begin <text>, | exclude <text>, and | include <text>. The
include modifier limits output to lines that contain the specified text, the exclude modifier
excludes any lines with the specified text, and the begin modifier displays the first line of
output with the specified text and all lines thereafter.
For specific instructions and examples regarding these modifiers, refer to the introduction
of the Enable Mode Command Set on page
Syntax Description
cos-map
dscp-cos
interface <interface>
queuing
Default Values
No default values are necessary for this command.
Command History
Release 6.1
Release 7.1
Release 17.1
60000CRG0-35E
Displays the CoS priority-to-queue map. The map outlines which CoS
priority is associated with which queue.
Displays the differentiated services code point (DSCP) to CoS map
settings.
Displays the configured values for default CoS and trust settings on a
specific interface. Specify an interface in the format <interface type [slot/port
| slot/port.subinterface id | interface id | interface id.subinterface id | ap |
ap/radio | ap/radio.vap]>. For example, for a T1 interface, use t1 0/1; for an
Ethernet subinterface, use eth 0/1.1; for a PPP interface, use ppp 1; for an
ATM subinterface, use atm 1.1; and for a wireless virtual access point, use
dot11ap 1/1.1. Type show qos interface ? for a complete list of valid
interfaces.
Displays the type of queuing being used. If weighted round robin (WRR)
queuing is enabled, the command also displays the weight of each queue.
Command was introduced.
Command was expanded to include the dscp-cos parameter.
Command was expanded to include the modifiers begin, exclude, and
include.
Copyright © 2012 ADTRAN, Inc.
Enable Mode Command Set
83.
708