ADTRAN AOS Version R10.1.0 Command Reference Manual page 258

Command Reference Guide
debug ethernet cfm loopback
Use the debug ethernet cfm loopback command to activate debug messages associated with Ethernet
operations, administration, and maintenance (OAM) connectivity fault management (CFM) loopback
message paths. Debug messages are displayed (real time) on the terminal (or Telnet) screen. Use the no
form of this command to disable the debug messages. Variations of this command include:
debug ethernet cfm loopback request
debug ethernet cfm loopback request domain <domain name>
debug ethernet cfm loopback request domain <domain name> association <association name>
debug ethernet cfm loopback request domain <domain name> association <association name>
mep <mep id>
debug ethernet cfm loopback response
debug ethernet cfm loopback response domain <domain name>
debug ethernet cfm loopback response domain <domain name> association <association name>
debug ethernet cfm loopback response domain <domain name> association <association name>
mep <mep id>
Turning on a large amount of debug information can adversely affect the performance of
your unit.
Syntax Description
request
response
domain <domain name>
association <association name> Optional. Specifies that debug output is limited to loopback message
mep <mep id>
Default Values
By default, all debug messages in AOS are disabled.
Command History
Release 17.4
60000CRG0-35E
Specifies debug messages are enabled for loopback message request
paths.
Specifies debug messages are enabled for loopback message
response paths.
Optional. Specifies that debug output is limited to loopback message
path information for maintenance endpoints (MEPs) of a specific
domain.
path information for MEPs of a specific association.
Optional. Specifies that debug output is limited to loopback message
path information for MEPs that match a specific MEP ID. MEP ID range
is 1 to 8191.
Command was introduced.
Copyright © 2012 ADTRAN, Inc.
Enable Mode Command Set
258