ADTRAN AOS Version R10.1.0 Command Reference Manual page 703

Command Reference Guide
show probe
Use the show probe command to display probe configuration and statistics. Refer to
Probe Command Set on page 2938
command include the following:
show probe
show probe <name>
show probe <name> realtime
show probe responder icmp-timestamp
show probe responder icmp-timestamp realtime
show probe responder twamp
show probe responder twamp realtime
show probe responder udp-echo
show probe responder udp-echo realtime
show probe <name> statistics
show probe <name> statistics history
show probe statistics
show probe statistics history
The output of all show commands can be limited by appending the following modifiers to
the end of the command: | begin <text>, | exclude <text>, and | include <text>. The
include modifier limits output to lines that contain the specified text, the exclude modifier
excludes any lines with the specified text, and the begin modifier displays the first line of
output with the specified text and all lines thereafter.
For specific instructions and examples regarding these modifiers, refer to the introduction
of the Enable Mode Command Set on page
Using the realtime argument for this command can adversely affect the performance of
your unit.
Syntax Description
<name>
responder
icmp-timestamp
twamp
udp-echo
statistics
history
60000CRG0-35E
for information on configuring probe objects. Variations of this
Optional. Displays configuration and statistics for a specific probe.
Displays the specified probe responder statistics.
Optional. Displays the Internet Control Message Protocol (ICMP) timestamp
probe responder statistics.
Optional. Displays the Two-Way Active Measurement Protocol (TWAMP)
probe responder statistics.
Optional. Clears the User Datagram Protocol (UDP) echo probe responder
statistics.
Optional. Displays measured probe statistics.
Optional. Displays the history of all measured probe statistics.
Copyright © 2012 ADTRAN, Inc.
Enable Mode Command Set
83.
Network Monitor
703