ADTRAN AOS Version R10.1.0 Command Reference Manual page 209

Command Reference Guide
The following example copies the current running configuration to CompactFlash memory and names the
file config_01.txt:
>enable
#copy running-config cflash config_01.txt
Percent Compete 100%
#
The following example copies the current running configuration to a TFTP server and names the file
config_01.txt:
>enable
#copy running-config tftp
Address of remote host? 10.200.2.4
Destination filename? config_01.txt
Initiating TFTP transfer...
Sent 3099 bytes.
Transfer Complete!
The following example copies the current running configuration to the connected terminal using XMODEM
protocol:
>enable
#copy running-config xmodem
Begin the Xmodem transfer now...
Press CTRL+X twice to cancel
CCCCCC
AOS is now ready to transmit the file on the CONSOLE port (using the XMODEM protocol). The next step
in the process may differ depending on the type of terminal emulation software you are using. For
HyperTerminal, you will now select Transfer > Receive File and select the destination. Once the transfer
is complete, information similar to the following is displayed:
Sent 3704 bytes.
Transfer complete
60000CRG0-35E Copyright © 2012 ADTRAN, Inc.
Enable Mode Command Set
209