ADTRAN AOS Version R10.1.0 Command Reference Manual page 920

Command Reference Guide
crypto ike
Use the crypto ike command to define the system-level local ID for Internet key exchange (IKE)
negotiations and to enter the IKE Client or IKE Policy command sets. Use the no form of this command to
disable these features. Variations of this command include the following:
crypto ike client configuration pool <name>
crypto ike local-id address
crypto ike policy <value>
Syntax Description
client configuration pool <name>
local-id address
policy <value>
Default Values
No default values are necessary for this command.
Command History
Release 4.1
Usage Examples
The following example creates an IKE policy with a policy priority setting of 1 and enters the IKE Policy for
that policy:
(config)#crypto ike policy 1
60000CRG0-35E
Creates a local pool, assigns it the name of your choice and
enters the IKE Client command set. Clients that connect via an
IKE policy that specifies this pool name will be assigned values
from this pool. Refer to the section
page 3955 for more information.
Sets the local ID during IKE negotiation to be the IP address of
the interface from which the traffic exits. This setting can be
overridden on a per-policy basis using the local-id command.
Refer to local-id on page 3963
Creates an IKE policy, assigns the sequence number value of
your choice, and enters the IKE Policy command set. Refer to
section IKE Policy Command Set on page 3955
information.
Command was introduced.
Copyright © 2012 ADTRAN, Inc.
Global Configuration Mode Command Set
IKE Policy Command Set on
for more information.
for more
920