ADTRAN AOS Version R10.1.0 Command Reference Manual page 403

Command Reference Guide
zero
dscp <value>
interval <value>
port <port>
repeat <value>
size <value>
source <ip address>
source-port <port>
timeout <value>
verbose
wait <value>
Default Values
By default, the data is zero, the dscp is 0, the interval value is 20, the port value is 0, the repeat value is
100, the size is 0, and the timeout is 2000 milliseconds.
Command History
Release 17.4
Release 17.6
Release A4.01
Functional Notes
The ping twamp command can be issued from both the Basic and Enable modes.
Usage Examples
The following example executes a TWAMP ping:
>enable
#ping twamp
2009.06.03 11:18:24 IP.TWPING CTRL EVNT Attempting to connect
2009.06.03 11:18:24 IP.TWPING CTRL EVNT State changed Init -> Opening (event=Open Connection)
2009.06.03 11:18:24 IP.TWPING CTRL EVNT State changed Opening -> Setup (event=RX
Server-Greeting)
60000CRG0-35E
Pads the packet with all zeros.
Optional. Specifies the differentiated services code point (DSCP) value.
Valid range is 0 to 63.
Optional. Specifies the interval between consecutive ping TWAMPs (in
milliseconds). Valid range is 5 to 5000.
Optional. Specifies the destination port for the TWAMP test packets. Valid
range is 1 to 65535.
Optional. Specifies the number of ping TWAMP packets. Valid range is 1 to
1000.
Optional. Specifies the datagram size. Valid range is 0 to 1462.
Optional. Specifies the source IP address. IP addresses should be
expressed in dotted decimal notation (for example, 10.10.10.1).
Optional. Specifies the source port for the TWAMP test packets. Valid range
is 1 to 65535.
Optional. Specifies the timeout value in milliseconds. Valid range is 100 to
60000.
Optional. Displays the detailed two-way ping verbose results for the
specified IP address or host name.
Optional. Specifies the interval (in milliseconds) between consecutive
TWAMP test packets. Range is 5 to 5000.
Command was introduced to replace the twping command.
Command was expanded to include control-port and wait keywords.
Command was expanded to include the ascii and hex pattern parameters.
Copyright © 2012 ADTRAN, Inc.
Enable Mode Command Set
403