ADTRAN AOS Version R10.1.0 Command Reference Manual page 930

Command Reference Guide
data-call
Use the data-call command to set the preauthentication defaults for inbound demand routing calls. Use the
no form of this command to return to the default setting. Variations of this command include:
data-call authentication protocol chap
data-call authentication protocol pap
data-call mtu <number>
data-call multilink
data-call sent authentication protocol chap
data-call sent authentication protocol pap
Syntax Description
authentication protocol
chap
pap
mtu <number>
multilink
sent authentication protocol
Default Values
By default, the authentication protocol is not configured, multilink is disabled, and the maximum
transmission unit (MTU) size is 1500.
Command History
Release 11.1
Functional Notes
There are certain Point-to-Point Protocol (PPP) parameters that must be known before PPP can negotiate
an inbound call when using demand routing. To ensure PPP convergence, it is recommended (in most
cases) that demand routing interfaces use the same settings as those specified in the data-call
commands. The data-call mtu <number> command sets the MTU and controls the negotiated MRU size
during incoming calls for Link Control Protocol (LCP) negotiation. If the PPP parameters do not match the
authenticated user, the link is renegotiated.
60000CRG0-35E
Sets the authentication protocol expected for inbound calls. For more
detailed information on Challenge-Handshake Authentication Protocol
(CHAP) and Password Authentication Protocol (PAP), refer to the
Technology Review section of the command
page 2569.
Configures CHAP authentication.
Configures PAP authentication.
Sets the maximum size for the transmit unit. Valid range is 64 to 1520.
Refer to the command
2567 for more detailed syntax descriptions.
Enables the negotiation of multilink maximum receive unit (MRU) size
for inbound calls.
Sets the authentication protocol sent for inbound calls. For more
detailed information on CHAP and PAP, refer to the Technology Review
section of the command
Command was introduced.
Copyright © 2012 ADTRAN, Inc.
Global Configuration Mode Command Set
ppp authentication on
peer default ip address <ipv4 address> on page
ppp authentication on page 2569.
930